Apologies if this is covered previously, but I'm just getting aclimated to the protect environment and as I can tell through my initial testing, a domain member VM that is powered down and that I've been able to scan succesfully, fails with an "invalid guest credentials" error on patch deployment install.
I've tested and the only way I can alleviate the issue is to login to the VM in question using the credentials specified in the protect deploy job.
At this point, I can run the deploy action from protect and it will patch successfully. Is there a pre-req to at least have logged in to the VM using the credential being used by the deploy job?
I haven't noticed this req in the documentation, but I'm also relatively new to the product and its specifc requirements. Any feedback is appreciated.
Thanks- Nick
